HID Barcode enabled
Reading Barcode:
- Pressing trigger down à barcode aimer starts àReleasing trigger àscanning start
- When tag found, result is sent to HID immediately
- Pressing trigger down during scan à scanning aborted
HID RFID enabled
Reading RFID tags:
- Pressing trigger down à RFID reading starts
- Reader read tags and stores them in memory as long trigger is kept down. Short beep when new tags found
- Releasing trigger à Reading stops and tags in memory will be transmitted to HID. Short beep when single tag sent. If no tags found, double low note beeps
| NOTE! HID operation is slow and it’s not very useful for cases where need to read and transfer high amount of tags (> 5) |
Both: HID Barcode & HID RFID enabled.
Activate Barcode reader:
- Trigger click (short press (<350ms) and released immediately) à Barcode scanning starts immediately without aiming.
- Trigger press and keeping down at least 350ms à Barcode aimer starts à Trigger released à scanning starts.
Activate RFID reader:
- Pressing trigger “double click” and keeping down à RFID reading starts. Searching tags. Beep when tags found.
- Releasing trigger à Reading stops and tags in memory will be transmitted to HID. Short beep when a single tag sent. If no tags found, double low note beeps.
- Pressing trigger during tag sending à aborted.
- Pressing trigger during barcode scanning à aborted.